user_manual:sesamx:functions_description:create_contact

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
user_manual:sesamx:functions_description:create_contact [2023/01/28 11:36]
Ali Baba 		user_manual:sesamx:functions_description:create_contact [2023/01/28 15:27]
Ali Baba [Symmetric contact condition]
Line 106: Line 106:
 <label type="info">optional</label> <label type="info">optional</label>
  
-This branch is used to define a node-to-surface contact condition. You must provide the zone master elements with the ''ON-ELEMENTS-FROM'' selection, and the zone slave nodes with the ''ON-NODES-FROM selection''. To complete this definition, you must also provide the zone tolerance (''TOLERANCE'') used to detect potential contact during the resolution.+This branch is used to define a node-to-surface contact condition. You must provide the zone master elements with the ''ON-ELEMENTS-FROM'' selection, and the zone slave nodes with the ''ON-NODES-FROM'' selection. To complete this definition, you must also provide the zone tolerance (''TOLERANCE'') used to detect potential contact during the resolution.
  
 === Keywords === === Keywords ===
Line 136: Line 136:
 ==== Symmetric contact condition ==== ==== Symmetric contact condition ====
  
-This example showcases a symmetric contact condition obtained by superimposing 2 NTS contact zones where the slave and master selection are switched.+This example showcases a symmetric contact condition obtained by superimposing 2 NTS contact zones where the slave and master selections are switched.
  
 <code php> <code php>
  • user_manual/sesamx/functions_description/create_contact.txt
  • Last modified: 2023/01/28 15:27
  • by Ali Baba